What the Black Thunder II Power Cable Does
The StraightWire Black Thunder II is a premium power cable designed for high-level components with IEC female receptacles. It is an excellent upgrade for Aperion Energy Pro High Power Amplifiers such as the E2H and E3H, as well as other audio equipment. Its construction uses 10 gauge stranded oxygen-free copper with six 18-gauge conductors per polarity, shielded and covered in a flexible black mesh jacket. This design helps minimize electromagnetic effects and noise while maintaining dynamics.
Key Specifications at a Glance
- StraightWire Black Thunder II Power Cable - 20 Amp for E2H/ E3H: 10 gauge Stranded Oxygen Free Copper, 6 @ 18 Gauge per polarity, shielded This heavy-gauge construction reduces resistance and handles high current demands of amplifiers like the E2H and E3H.

StraightWire Black Thunder II Power Cable - 20 Amp for E2H/ E3H - StraightWire Black Thunder II Power Cable - 20 Amp for E2H/ E3H: OD 11mm The 11mm outer diameter means the cable is thick but still manageable for routing in a rack or behind equipment.
- StraightWire Black Thunder II Power Cable - 20 Amp for E2H/ E3H: Flexible Black mesh covered Jacket, PFA insulation The flexible jacket makes installation easier in tight spaces, and PFA insulation provides durability and heat resistance.
Installation Steps
Before you begin, make sure your equipment is powered off and unplugged. The Black Thunder II is a direct replacement for your existing power cable. Follow these steps for a clean installation.
- 1. Power Down and Unplug: Turn off your amplifier or component and disconnect it from the wall outlet. Wait a few minutes for capacitors to discharge.
- 2. Remove the Existing Cable: Gently pull the old IEC cable from the component's power inlet. Avoid yanking the cable; grip the connector body.
- 3. Connect the Black Thunder II: Align the IEC connector with the component's inlet and push firmly until it clicks into place. Ensure the connection is snug but not forced.
- 4. Plug into Wall or Power Conditioner: Connect the 20 Amp plug end to a suitable wall outlet or power conditioner. Verify the outlet matches the cable's rating.
- 5. Manage Cable Routing: Route the cable away from signal cables to minimize potential interference. Use cable ties or clips to secure it without bending sharply.
- 6. Power On and Test: After all connections are secure, power on your system. Listen for any hum or noise; if present, check connections and cable routing.
Mechanical and Electrical Considerations
The Black Thunder II addresses two types of issues: mechanical and electrical. Low-frequency vibrations (60-240 Hz harmonics) can cause noise in power supplies. The cable's shielded twisted helical pair design helps reduce these vibrations. Electrically, leakages, magnetic field effects, and induced noise depend on how well the power supply is shielded and physically coupled to the chassis. Overall shielding and grounding of the component is quite important. The Black Thunder II's construction with shielded low resistance conductors minimizes these effects.
Choosing the Right Length
The Black Thunder II is available in lengths from 0.5M to 3.0M. Choose a length that allows a clean cable path without excess slack. A shorter cable reduces potential interference and clutter, while a longer cable provides flexibility for rack placement.


